Carbatec Sanders | SHOP BY CATEGORY 630Mm Sander Wide Drum Wds-630C

Product Description

Features powerful 3hp / 230v single phase motor. The variable speed rubberised feed belt protects the underside of panels during infeed while holding them in place to pass under the sanding heads. Abrasives are spirally wound onto the both drums and are tensioned at both ends with spring clips – setup takes only a few minutes, even less with some practice. The optimal way for the drums to be configured is with coarse paper on the front drum and fine paper on the rear to allow you to produce a finished board in one pass. This dramatically reduces your hand sanding time and is a wonderful common sense. A drum setting gauge is factory fitted and helps make this process simple and easy. Adequate dust extraction – 2HP (at least 1200CFM) is a prerequisite for using this machine. Without adequate dust extraction papers become clogged and will not perform optimally. Requires 15Amp power point and circuit which must be installed by a licensed electrician. 3HP, 240v induction motor 620mm sanding width Dual drum capacity Rubberised feed platen Feed speeds range from 1 to 6 metres per minute Two 4″ (100mm) dust ports Dust extraction required for optimal performance